How to use the live-streaming function of Insta360 Pro?

1. Operation instructions

- - - Select the live video broadcast mode from the homepage, press “POWER” key to confirm entering such mode. After the camera completes the preparation, the LIVE VIDEO BROADCAST READY state will be displayed.
      - When the live video broadcast mode is in LIVE VIDEO BROADCAST READY state, press UP and DOWN keys to switch over the size levels for broadcasting.
      - When the live video broadcast mode is in LIVE VIDEO BROADCAST READY state, press POWER key to switch over the size levels for push stream live video broadcasting or for output live video broadcast via HDMI. Press POWER key again during live video broadcast and the broadcasting will be stopped. The work indicating lamp will flash continuously during live video broadcasting until the broadcasting is completed and the video is stored. If the broadcasting environment may be affected, turn off the LED in the setting function of the camera.

- - - - If the push stream is abnormally interrupted due to network abnormality during live video broadcasting, the camera will continue try to reconnect it without manually stopping the live video broadcast until the push stream live video broadcasting is recovered.

- - - - The user can set the push steam address through the client end, or set that the original video is stored locally while the live video broadcast is going on. Suppose it is set that the video is stored locally while the live video broadcast is going on, the abnormality that appears in the video recording may occur in this case.
      - If the camera's electricity quantity is too low during live video broadcast, it will automatically stop the live video broadcast and prompt the battery is too low in electricity. Please connect the power adapter immediately or replace the battery with sufficient power. Otherwise, you can no longer proceed with the next live video broadcast.
      - If there is an error prompt during the live video broadcast, it means that the operation is not completed properly, please refer to the relevant error instructions and get a solution (this requires that Wan Shun and Xiao Shen summarize the current archiving errors)

2. Push Stream Live Video Broadcast Size and Broadcasting Levels

- - - - 4K/30F-4KPano@30fps，push stream for network live video broadcast. If the push steam address is not set, the internal push stream will be defaulted. You can set in the client-end app to save the original video (of live-streaming) into the storage card during live-streaming.
      - 4K/3D30F- 4K3D@30fps，push stream for network live video broadcast If the push steam address is not set, the internal push stream will be defaulted. You can set in the client-end app to save the original video (of live-streaming) into the storage card during live-streaming. However, the high frame rate will drop to 24fps, and the real-time video stitching may be achieved.
      - 4K/30F HDMI —— 4KPano@30fps, HDMI output signal. You can set in the client-end app to save the original video (of live-streaming) into the storage card during live-streaming.
      - 44K/3D/30F HDMI - 4K3D@30fps，HDMI HDMI output signal. It may be set through the client-end storage card that the original video is stored into the storage card while the live video broadcast is going on. However, the high frame rate will drop to 24fps, and the real-time video stitching may be achieved.
      - Aerial —— aerial photo mode. In this mode, the 1920x960 HDMI panoramic images will be output to UAV for preview, and the original video with the resolution of 2560x1440 of each lens may be saved.
      - Customize -The user can quickly select the latest APP operation of this application, or the parameters stored by scanning the QR code.

Was this information helpful?

Yes

Consumer

Conferencing

Professional

Where to buy

Support

Partners

About us

Consumer

Conferencing

Professional

Where to buy

Support

Partners

About us

Subscribe